--- title: "Disaster Recovery for Lasernet Archive" slug: "disaster-recovery-for-lasernet-archive" description: "Disaster recovery guidance for standalone Archive servers." tags: ["Lasernet Archive", "Disaster recovery", "Standalone"] updated: 2026-11-20T11:44:18Z published: 2026-11-20T11:44:18Z canonical: "kb.lasernetgroup.com/disaster-recovery-for-lasernet-archive" --- > ## Documentation Index > Fetch the complete documentation index at: https://kb.lasernetgroup.com/llms.txt > Use this file to discover all available pages before exploring further. # Disaster Recovery for Lasernet Archive This article provides information and guidance on how to approach the recovery and restoration of Lasernet Archive 11.0 and later in a disaster scenario. It applies only to standalone installations. ## Overview If a disaster occurs, you typically need to do the following to recover the Archive system: - Replace failed hardware or redeploy a virtual machine. - Reinstall software using the [Installation Guide](/v1/docs/lasernet-keep-installation-guide). - Restore system data from backups using the [Backup and Restore Lasernet Archive](/v1/docs/back-up-and-restore-lasernet-keep) guide. > [!NOTE] > Note > > Recovery steps depend on your system configuration and the type of failure. Review the following sections carefully before starting the recovery process. ### Server Hardware Failure Where available, switch to a preconfigured disaster recovery (DR) server to minimize downtime. If a DR server is not in place, either: - Install Archive on a new standalone server. - Replace faulty hardware on the existing server, and then reinstall Archive. ### Virtual Machine Failures If Archive is deployed as a virtual machine (VM), restoring the VM from backup is often the quickest recovery option. If this is not possible, read the following sections to reinstall and restore Archive. ### Lasernet Archive Server Software Recovery When reinstalling Archive, it is important to use the same software version as the original system. If these files are not available from backup, contact [Lasernet Support](https://support.lasernetgroup.com/new-ticket). If you have a backup of the original `.properties` file, you can use it to perform a silent, automated installation, following the Installation Guide. After reinstalling Archive, use the [Backup and Restore Lasernet Archive](/v1/docs/back-up-and-restore-lasernet-keep) guide to restore the following folders and synchronize them with the Lasernet Archive database: - Documents archive folder - Chunks folder #### Software Licensing The Archive license is tied to the database server hostname and database name. Therefore, only changes to the database server itself trigger a new requirement. For this reason, failover of the application's active-passive setup would not trigger a license change. If license activation fails after recovery, you can use Archive in evaluation mode, which allows the system to run for 30 days without a full license. This should give you enough to get your system up and running again whilst you contact [Lasernet Support](https://support.lasernetgroup.com/new-ticket) for assistance. ### Database Server Recovery If the database server fails, restore from the most recent backup. Make sure that you restore the following from the same backup as the database: - Documents archive folder - Chunks folder - Encryption master password (if enabled) You must restore from the same backup because the database contains metadata records, while the documents archive folder contains the associated image files, such as scanned PDFs. Restoring mismatched backups may result in missing or inaccessible documents. ### System Configuration Refer to the [Lasernet Archive System Requirements](/v1/docs/lasernet-keep-system-requirements) for information on the minimum requirements to install the Archive server.